AirPlus KRT2 Uživatelský manuál stáhnout pdf (Strana 13)

User manual & instruction for

installation

remote control for

VHF-Communication Tranceiver

Doc.-Nr:

GT-3000-810100

KRT2

Revision 1.0

5.3. Unpacking and controlling of device

Carefully unpack the equipment. Damages due to transportation

must immediately be reported to the shipping company. Save the

shipping container and all packing material to substantiate your

claim.

For storage or reshipment the original packing material

should be used.

5.4. Installation

• In cooperation with the maintenance shop, mounting details are

specified. The maintenance shop can manufacture and install all

cables that may be required.

• Avoid installing the unit in the vicinity of heat sources. Sufficient

air-circulation is required.

• There must be sufficient space for cables and connectors.

• Avoid sharp bends and wiring close to control cables.

• Cable length must be such that connectors are accessible for

repair.

• The wiring to the transceiver must be installed such that water

droplets formed by condensation will not run into the connector.

• Remove the turning knob in order to install the transceiver:

o Remove the turning knob cap with an appropriate tool.

o Loosen the screw and remove the turning knob.

o Install cap correctly oriented!

• Installation is from the front side of the instrument panel with

three 4mm screws in a 57mm panel cut-out.

• For installation details and drawings refer to chapter 5.1

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 19 20

Žádné komentáře

AirPlus KRT2 Uživatelský manuál Strana 13